Hot search:

Home&DIY Category

·Maybe you want to read these
Hot Home&DIY

@WiringCircuit

>> Home > Home&DIY > Touch Switch

Touch Switch

2012-05-31 Posted by:circuit Source:Internet Visits: Comment () Size:L M S

Summary:Turn on and turn off your electrical devices using touch switch, so you can play your electronic devices more fun.. . Touch switch dont need mechanical part, so they will not worn out due to mechanical contact. Touch switches can be used in

Turn on and turn off your electrical devices using touch switch, so you can “play” your electronic devices more fun.. Touch Switch circuit . Touch switch don’t need mechanical part, so they will not worn out due to mechanical contact. Touch switches can be used in places where regular switches would not last, such as wet or very dusty areas. You just need to add some relay to switch your devices which require high voltage supply.

Here the schematic diagram:

Touch Switch circuit

Component part list:

Part      Total Qty.    Description

C1         1          10uF 16V     Electrolytic Capacitor
R1, R2     2          100K 1/4 Watt Resistor
R3         1          10 Meg 1/4 Watt Resistor
U1         1          4011 CMOS NAND Gate IC
MISC       1          Board, Wire, Socket For U1

Notes:

1. The contacts an be made with just two loops of wire close together, or two squares etched close together on a PC board.

2. When activated, the output of the circuit goes high for about one second. This pulse can be used to drive a relay, transistor, other logic, etc.

3. You can vary the length of the output pulse by using a smaller or larger capacitor for C1.

Just try touch switch circuit… Touch Switch circuit


Good
(0)
0%
Bad
(0)
0%
-------------------------------------
Circuit Notice

If the circuit&wiring in《Touch Switch》was too small to read, you should download them!

@Wiring Circuit@

@New comment
      What's the feeling for you?
      Face:
      Comment:
      Change the code
      * Ctrl+ENTER To Sent

      @READ EXPLANATION

      ☉If you have any questions, please don't mind to tell us.