Hot search:

Hot Control&Switch Circuit

@WiringCircuit

>> Home > Control&Switch Circuit > Wireless On-Off Switch

Wireless On-Off Switch

2013-06-25 Posted by:electronic Source:Internet Visits: Comment () Size:L M S

Summary:Wireless On-Off Switch Circuit Description Normally home appliances are controlled by means of switches, sensors, etc. However, physical contact with switches may be dangerous if there is any shorting. The circuit described here requires no

Wireless On-Off Switch

Circuit Description

Normally home appliances are controlled by means of switches, sensors, etc. However, physical contact with switches may be dangerous if there is any shorting. The circuit described here requires no physical contact for operating the appliance. You just need to move your hand between the infrared LED (D2) and the phototransistor (Q1). The infrared rays transmitted by D2 is detected by the phototransistor to activate the hidden lock, flush system, hand dryer or else. This circuit is very stable and sensitive compared to other AC appliance control circuits. It is simple, compact and cheap. Current consumption is low in milliamperes. The circuit is built around an IC CA3140, D2, phototransistor and other discrete components.

Circuit Diagram:

Wireless On-Off Switch-Circuit Diagram

Parts:

  • R1 = 470R
  • R2 = 100K
  • R3 = 3.3K
  • R4 = 10K
  • D1 = 1N4007
  • D2 = IR LED
  • Q1 = L14F1
  • RL = 5Vdc Relay
  • IC = CA3140
  • Q2 = BC548

Circuit Operation:

When regulated 5V is connected to the circuit, D2 emits infrared rays, which are received by phototransistor Q1 if it is properly aligned. The collector of Q1 is connected to non-inverting pin 3 of IC1. Inverting pin 2 of IC1 is connected to voltage-divider preset R4. Using preset R4 you can vary the reference voltage at pin 2, which also affects sensitivity of the phototransistor. Op-amp IC1 amplifies the signal received from the phototransistor. Resistor R3 controls the base current of transistor BC548 (Q2). The high output of IC1 at pin 6 drives transistor Q2 to energies relay RL1 and switch on the appliance, say, hand dryer, through the relay contacts. The working of the circuit is simple. In order to switch on the appliance, you simply interrupt the infrared rays falling on the phototransistor through your hand. During the interruption, the appliance remains on through the relay. When you remove your hand from the infrared beam, the appliance turns off through the relay. Assemble the circuit on any general-purpose PCB. Identify the resistors through colour coding or using the multimeter. Check the polarity and pin configuration of the IC and mount it using base. After soldering the circuit, connect +5V supply to the circuit.

Good
(0)
0%
Bad
(0)
0%
Tags:circuit infrared
-------------------------------------
Circuit Notice

If the circuit&wiring in《Wireless On-Off Switch》was too small to read, you should download them!

@Wiring Circuit@

@New comment
      What's the feeling for you?
      Face:
      Comment:
      Change the code
      * Ctrl+ENTER To Sent

      @READ EXPLANATION

      ☉If you have any questions, please don't mind to tell us.